Hitachi C10FS/C12FSA Installation
In addition to the installation instructions these steps are provided.
1. Remove the chip shut from the base.
2. Remove the 4 screws at the back of the aluminum
3. Gently spread the two haves apart and remove the plastic deflector inside.
4. Cut the top square portion of the deflector off a about a 45 degree angle. This is to allow the laser beam to have clearance.
5. Re-assemble the chip shut and install it into the saw base.
6. Attach the W-1 bracket to the laser as shown
7. The slide should be pushed all the way back against the stop. The laser should be mounted so that it does not hit the frame.
8. The following pictures are to assist you in positioning the laser in direct line with the blade per the installation instructions.
8.1 Picture to assist you in positioning the laser in direct line with the blade per the installation instructions.